Awesome Water thermostat replacement

If persists you may need to change the cold internal
reader as follows
Open machine.

1. Unscrew 1 or 2 screws holding the
2. reservoir and tilt back foe access.
3. Gouge out the block of foam covering the reader (follow the wire)
4. Pull out reader and wire (may need to clear
5. silicon holding both in place)
6. Replace internal reader (drop of silicon will hold in place but keep it away from the metal bullet and only at the entrance so it can be cleared in future if you need to replace again)
7. Replace foam (again – silicon of “gap filling foam”
8. is handy for holding in place)
9. Re-connect end of internal reader wire to digi panel or rear switch depending on machine type.